• Lightweight (7g)
• Low profile design
• Tough Polycarbonate Contruction
• Easy-to-use
• Dust and water resistant
• 50lb rating

The lightest and most compact vertical mount available. It is a direct drop-in replacement for the stock battery door.

Features a water and dust resistant foam seal (does not maintain factory waterproof standard), and a spring loaded snap-fit design to ensure that it stays locked in place.

Installation instructions:

1. Remove the stock battery door.

2. Snap the top of the battery door onto the pin on the camera chassis.

3. Close the battery door and apply pressure to snap the latch into place at the bottom end of the door.

Removal Instructions:

1. Open the door by pressing inward on the battery door's mounting tabs, while pulling back on the latch at the bottom of the door. 

2. Open the door so it is 90 degrees to the camera, and pull straight back to disconnect it.

 Camera and other accessories not included.